Authors:

AAIA Sri Komaladewi, DNK Putra Negara

Abstract:

“In order to obtain desired results of machining process (turning), parameter of process and material characteristic to be machined should be well known. This is due to different machining conditions and material yield different material machinability as well. It is needed to investigate of material machinability (AISI 1040) such as force, power and shear angle under different cutting speed (80, 160 and 240 m/min) and feed rate (0.1, 0.2, and 0.3 mm/rev). The results of investigation show that; at the same cutting speed the higher feed rate the higher cutting force needed; the higher cutting speed and feed rate, the higher power needed; at feed rate 0.1 mm./rev and 0.3 mm/rev, the higher cutting speed the shear angles has a trend to incline; at feed rate 0.2 mm/rev, cutting speed from 80 to 160 m/min yield increasing of shear angle, however, from 160 to 240 m/min shear angle declines.”

Keywords

Keyword Not Available

Downloads:

Download data is not yet available.

References

References Not Available

PDF:

https://jurnal.harianregional.com/jem/full-2238

Published

2021-11-09

How To Cite

SRI KOMALADEWI, AAIA; PUTRA NEGARA, DNK. Machinability baja AISI 1040 pada proses bubut dengan variasi cutting speed dan feed rate.Jurnal Energi Dan Manufaktur, [S.l.], nov. 2012. ISSN 2541-5328. Available at: https://jurnal.harianregional.com/jem/id-2238. Date accessed: 28 Aug. 2025.

Citation Format

ABNT, APA, BibTeX, CBE, EndNote - EndNote format (Macintosh & Windows), MLA, ProCite - RIS format (Macintosh & Windows), RefWorks, Reference Manager - RIS format (Windows only), Turabian

Issue

Vol 1, No.2 Desember 2006

Section

Articles

Creative Commons License This work is licensed under a Creative Commons Attribution 4.0 International License